| Date |
Mileage |
Work Performed |
| 11/7/17 |
9,811 |
- Changed Oil and Filter:
- BMW Oil Filter
- Mobile 1 10W-40 Racing 4T Synthetic (3 qts)
- Cleaned and lubricated chain
- Checked Chain Play: 30mm (spec 30-40mm)
- Installed the following:
- AltRider Lower Crash Bars
- BMW Hand guards with spoilers
- Fused SAE plug
- New Front Tire – Michelin Anakee 3 (matches new rear tire installed by PO)
|
| 11/18/17 |
9,811 |
- Installed Kaoko CCF900 Cruise Control
|
| 12/12/17 |
9,930 |
- Changed Front and Rear Brake Fluid
- Flushed ABS
- Prestone DOT-4 Synthetic
- Rotated front reservoir rubber bushing
|
| 12/19/17 |
10,029 |
|
| 2/19/18 |
10,187 |
|
| 4/28/18 |
10,489 |
|
| 6/1/18 |
12,778 |
- Changed Oil and Filter ( ~7 months / 3000 miles)
- BMW Filter
- Castrol 10W-40 4T Synthetic Motorcycle Oil
- Check Valve Clearance (work performed by Vallantine Motor Works)
- Clearances within spec, no adjustment required
- New style valve cover gasket installed. Should fix minor leak
- Changed Spark Plugs (work performed by Vallantine Motor Works)
- Technically don’t need to change until 24k miles, work recommended by tech. Claimed they were only good for 18k miles.
- Kept old plugs as spares
- Inspected:
- Coolant level: OK
- Clutch play: OK
- Front/Rear brake:
- Pads OK, Front disc has a small amount of rotor warp
- Fluid Levels OK
- Hoses/Connections OK
- Tires pressure/depth: OK
- Side stand OK
- Steering-head bearing OK No fore/aft movement, easy turning
- Inspected, cleaned and adjusted drive chain.
- No fault codes, service-due date reset (Vallantine Motor Works)
- Cleaned air-filter with compressed air
- Re-installed AltRider crash bars:
- Lower crash bars torques:
- Upper bolt to Cylinder head: 48NM (BMW DVD)
- Lower bolts: 19NM (BMW DVD)
- Upper Crash bar torques
- 9NM (AltRider Instructions)
|
| 6/6/18 |
12,803 |
- Installed DIY radiator guard
|
| 6/20/18 |
12,810 |
- Installed new TKC 80 tires front and rear
- Installed Headlight Guard
|
| 4/16/19 |
15,895 |
- Changed Oil and Filter ( ~10 months / 3000 miles)
- BMW Filter
- Castrol 10W-40 4T Synthetic Motorcycle Oil
- Installed new TKC 80 tires front and rear. The removed TKC80’s have about about 2k/1k f/r miles tread remaining. Changed because there’s just not enough tread left for an upcoming 3k ride.
- Added a few drops of DOT-4 Synthetic brake fluid to rear.
- Cleaned air filter
- Adjusted clutch to 5mm play
- Checked coolant levels — OK
- Check brake pads — OK
- Deep clean chain and sprockets
- Checked for error codes (None found)
|
| 8/22/19 |
19,236 |
- Changed Oil and Filter ( ~4 months / 3300 miles)
- BMW Filter
- Castrol 10W-40 4T Synthetic Motorcycle Oil
- Checked Fault codes (none)
- Reset Service Indicator
- Check brake pads — OK
- Deep clean chain and sprockets
|
| 6/20/19 |
19,775 |
- Re-installed Anakee 3 front/rear tires. Tires have 3k miles on them. TKC 80 front has a lot of miles left, but the rear only had a few hundred miles left before the the center tread would be gone.
|
| 7/8/21 |
20,521 |
- Changed Oil and Filter ( ~23 months / 1285 miles)
- BMW Filter
- Castrol 10W-40 4T Synthetic Motorcycle Oil
- Drain Plug Torque 40NM/29Ft-lb
- Changed Front and Rear Brake Fluid
- Flushed ABS
- Valvoline DOT-4 Synthetic
- Checked Fault codes (none)
- Reset Service Indicator
- Check brake pads — OK
|
| 5/13/23 |
22,158 |
- Changed Oil and Filter ( ~22 months / 1600 miles)
- BMW Filter
- Castrol 10W-40 4T Synthetic Motorcycle Oil
- Drain Plug Torque 40NM/29Ft-l
- Checked Fault codes (none)
- Reset Service Indicator
- Check brake pads — OK
- Replaced Air Filter (BMW)
- Changed fork Oil (BMW)
- Replaced Battery (Yuasa YTX14-BS)
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
